|
FallonL1961's Profile
Membership information
Username |
FallonL1961 |
Email |
Hidden |
User type |
Member |
Title |
None |
Posts |
0 |
Date Registered |
December 6th, 2012 |
Last Active |
December 6th, 2012 |
Personal information
Website |
best stocks for |
Real name |
Steven |
Location |
Cleveland |
Gender |
Female |
Age |
|
MSN Messenger |
|
AOL Instant Messenger |
|
Yahoo Messenger |
|
ICQ |
|
Bio |
1 position of confusion for some CCNA and CCNP candidates is the big difference among configuring a static default route and utilizing the Cisco routing command ip default-network.
At initially look, they seem to do the exact same point. The two configure a destination to which packets must be routed if there is no additional specific route pennystocks2232.com in the routing table.
The main distinction in between these two choices is that configuring a static default route only defines a default route for the router you happen to be configuring it on, whilst ip default-network will propagate the route by way of its routing protocol.
Let us take a look at the routing tables of a hub-and-spoke network working with the ip default-network day trading command. R1 is the hub and R2 and R3 are the spokes. They are straight related via the network 172.12.123. /24, and every single has a loopback with a 32-little bit mask that are numbered in accordance to the router range (one.one.1.1, and so on.) RIP is jogging on all three routers and the loopbacks are advertised.
R1 has an additional serial interface with the IP deal with ten.one.one.one /24, and this network has been flagged as a default network with the command ip default-network 10... . It is not currently being marketed by RIP.
The routing protocol will then market this route. With RIP, the default network is marketed as ... . (With IGRP, it appears as the network quantity, but is marked as an IGRP Exterior route. ) This route has been designated a applicant default route on R1, as we see with the asterisk subsequent to the ten... /24 network (code table eliminated for brevity)
R1show ip pennystocks4509.com route
Gateway of very last resort is not set
one.../32 is subnetted, 1 subnets
C one.one.one.1 is right linked, Loopback0
R two.../eight a hundred and twenty/1 by way of 172.12.123.two, 000011, Serial0
R three.../8 120/one through 172.12.123.3, 000011, Serial0
172.twelve../sixteen is variably subnetted, 2 subnets, two investment online masks
Do 172.12.21./30 is immediately linked, BRI0
Do 172.12.123./24 is straight linked, Serial0
* ten.../24 is subnetted, 1 subnets
C ten.one.one. is immediately linked, Serial1
On R2 and R3, a default RIP route is now seen (code tables all over again deleted)
R2show ip route
Gateway of very last exchange resort is 172.12.123.1 to network ...
R 1.../8 120/1 via 172.12.123.1, 000000, Serial0.213
two.../32 is subnetted, 1 subnets
C 2.two.two.2 is right related, Loopback0
R 3.../eight a hundred and twenty/2 through 172.twelve.123.1, 000000, Serial0.213
172.12../sixteen is variably subnetted, two subnets, 2 masks penny stocks
Do 172.twelve.21./thirty is right linked, BRI0
Do 172.twelve.123./24 is straight linked, Serial0.213
R* .../ a hundred and twenty/one through 172.12.123.1, 000000, Serial0.213
R3show ip route
Gateway of final resort is 172.twelve.123.one to network ...
R 1.../8 a hundred and twenty/one by way of 172.twelve.123.one, 000027, Serial0.31
R two.../eight 120/two by way of 172.twelve.123.one, 000028, Serial0.31
three.../32 is subnetted, one subnets
Do three.3.three.three is specifically connected, Loopback0
172.twelve../24 is subnetted, 1 subnets
C 172.12.123. is directly connected, Serial0.31
R* .../ a hundred and twenty/1 by means of 172.12.123.one, 000028, Serial0.31
And the default route works, because forex we can ping ten.1.one.one from both equally R2 and R3. Since they have no other match in their routing tables, they use the default route.
R2ping ten.1.1.1
Kind escape sequence to abort.
Sending five, one hundred-byte ICMP Echos to 10.1.one.one, timeout is two seconds
!!!!!
forex traders Accomplishment rate is 100 p.c (five/5), round-trip min/avg/max 68/68/68 ms
R3ping 10.1.1.one
Kind escape sequence to abort.
Sending five, a hundred-byte ICMP Echos to ten.one.1.1, timeout is 2 seconds
!!!!!
Accomplishment fee is 100 p.c (five/5), spherical-journey min/avg/max 68/68/68 ms
When fx trading determining whether or not to use a default static route or a default network, preserve in thoughts that if you want the routing protocol to propagate the default route, the ip default-network command will do that for you. But if you want only the nearby router to have the default route, a static IP route is the way to go.
|
Site information
Message Board signature |
|
Avatar |
|
|